Installation Guide

Wi-Fi WASP Infrastructure Installation Guide
Installation Guide
Section 5 Troubleshooting
Rev: 1 24 / 28
© Minetec 2019
5.2 Wi-Fi WASP™ Bridge
The troubleshooting steps below cover the physical installation of a Bridge only.
Check for Test Action for failed test
1) Physical
damage
Visually inspect the device for obvious physical
damage and ensure that it appears to be in
good physical order.
Contact your supervisor to
arrange a replacement
using the RMA Procedure
on page 26.
2) Environmental
problems
Is there any water around or under the power
connector?
Dry out connections and
mitigate further water
intrusion if no obvious
permanent damage.
3) Power supply
Does the daisy-chain segment where the
device is located have power?
Check Bridge for power
using Table 4 on page 18
Is the connector plugged in?
Connect cable.
Is the power source active?
Perform power source
troubleshooting.
Is 12-48 Vdc available from the source?
Is the power cable free of damage?
Replace cable.
4) Internal fault
LED states OK?
Refer to Table 4
on page
18.
5) Unresolved
If the problem is not resolved after performing
the above tests and actions.
Contact your supervisor to
arrange a replacement
using the RMA Procedure
on page 26.
Warranty is void if the device has been opened.