Installation Guide
Table Of Contents
Wi-Fi WASP Infrastructure Installation Guide
Installation Guide
Section 4 Installing Infrastructure
Rev: 1 19 / 28
© Minetec 2019
o Measure the distance to the first Access Point and Bridge and Ethernet points allowing for
some slack.
o Use the power and Ethernet cables prepared for the Access Point.
Terminate the Ethernet cable with the provided Ethernet connector in a straight through
configuration.
240Vac power wiring will be handled by the site electrician.
o Protect the cables in a protective sleeve according to site standards. Typically a solid nylon
conduit with end boots fitted is acceptable.
• Connect the power, Ethernet and earth connections. Install the batteries once in position as
these will add significant weight.
Figure 10 ICT cabinet schematic
4.3.2 ICT Cabinet installation
Before performing the steps in this guide, ensure all site operational, EHS and/or
maintenance practices are followed including, but not limited to the 'permit to work'
system, isolation of stored energy and use of the appropriate PPE.