Installation Guide

Wi-Fi WASP Infrastructure Installation Guide
Installation Guide
Section 4 Installing Infrastructure
Rev: 1 17 / 28
© Minetec 2019
Step
Action/Response
Comments
6) Check cables and
connections.
Check all connections, cables and
anchor points.
Do this before connecting to power.
7) Perform power-on
check.
Follow on-site operational and HSE
practises before applying power.
The power source will either be the
ICT cabinet, another Access Point or
a battery (eg if power not yet
available).
When ready, complete a basic
power-on check.
When power is turned on, all LEDs
should turn solid green to indicate
the device is working correctly and
ready to use. Refer to 4.2.3 for
details for expected LED states
when connected to power.
8) Mark up.
Mark up (red line) installation
drawings to indicate any changes to
installation locations (cabling or
Bridge).
Installation of the device is now
complete.
4.2.3 Bridge power-on check
The Bridge must be in the coverage area of the tracking system or a dedicated testing
installation.
Check the status of the Bridge LEDs described in Table 4 on page 18 to ensure that the device is
functioning correctly.
Figure 9 Bridge LEDs