Installation Guide

Wi-Fi WASP Infrastructure Installation Guide
Installation Guide
Section 4 Installing Infrastructure
Rev: 1 14 / 28
© Minetec 2019
Figure 5 Bridge with standard bracket
4.2.1 Before you start
Before commencing work, plan and prepare for the installation ensuring that you read, understand
and perform the appropriate planning and preparation steps including, but not limited to:
• Guidelines on page 4
.
• Planning on page 7.
• All electrical work to be done by qualified, authorised and deemed competent persons.
• The work area is clear and free from hazards.
• All relevant onsite permissions and permits to work have been obtained.
• All safety precautions are in line with Mine Operator policy.
• All required hardware and cabling is available.
Before commencing installation of Bridges, ensure you:
1) Confirm the intended location of the Bridge facilitates effective communication with Mobile
Nodes. Typically, Bridges are installed either on the side or in the middle of a tunnel, with the
antenna facing down, as shown in Figure 6 on page 15
.
For troubleshooting purposes, it is preferred that the LEDs visible from ground level.
2) Confirm the physical mounting location matches the location specific in the Detailed Design
document, supplied by Minetec.