Installation Guide

Wi-Fi WASP Infrastructure Installation Guide Installation

Guide

Rev: 1 i

Currency

Minetec makes every effort to ensure the accuracy and currency of all information contained in this document.

Minetec makes no expressed or implied warranty or representation based on the information presented in this

document. Minetec reserves the rights to change, alter and adjust equipment specifications and information

pertaining to the product information in this document without prior notice. Please report any errors or

omissions to the Product Assurance Manager, Minetec by emailing support@minetec.com.au

Minetec assumes no liability for damage incurred directly or indirectly from errors, omissions, or discrepancies

between the devices and the manuals.

MINETEC is the sole owner of the intellectual property contained in any documentation bearing its name. All

materials, including Internet pages, documents and online graphics, audio and video, are protected by

Apart from any fair dealing for the purposes of private study, research, criticism or review, as permitted under

the provisions of the Australian Copyright Act 1968, no part of this document may be reproduced, transmitted

in any form, or re-used for any commercial purposes whatsoever without written permission of Minetec. Note

that this document represents the status of the topic at the date shown and is subject to change without

notice. Contact Minetec to check for later releases.

MineView™ are trademarks of Minetec. Other brand, product, and company names mentioned in this

document are trademarks or registered trademarks of their respective holders. The English version takes

precedence over any translated versions.

Compliance

Labels located on the exterior of each device indicate the regulations with which the device complies.

Minetec systems and devices comply with the appropriate laws and regulations in Australia and New

Zealand. Minetec systems and devices comply with the appropriate laws and regulations of the

countries and regions as described in the product data sheets and any associated Compliance

Supplement. For any third-party devices refer to the vendors manuals for regulatory statements.

It is important to install and operate the devices and systems according to the

guidelines in this document to maintain conformity with regulations, standards and

directives.

Minetec is not responsible for modifications made by the end-user, or their

sub-contractors, and the consequences thereof, which may alter the conformity of the

product with the CE Marking.

Minetec Terms, Conditions and Warranty

Notwithstanding any contracts, agreements or support plans please refer to

http://minetec.com.au/minetec-terms-conditions-warranty

for the following:

• Minetec Standard Terms and Conditions of Sale.

• Minetec Software Licence Terms and Conditions.

• Minetec Warranty Statement.