Instruction manual

13
2 A
1 A
1
2
12.1 Power supply 1 x 230 V - DC motor
12.5 Stop motor setting S359 600045 XXX - EFKA DC 1600/DA82GA
12.5.1 Setting position reader
- set the parameter 170, the display will show Sr1 (reference position)
- depress the pushbutton >>, the display will show PoS 0 and the changing rotation symbol
- turn the hand wheel until the rotation symbol disappears
- turn the hand wheel in such a way, so that the needle point ,when moving downward, is on the level of the throat plate
- depress the pushbutton E and pass to the parameter 171
- set the parameter 171, the disply will show Sr2 (all positions)
- depress the pushbutton >>
- the display will show 1 XXX (value of the bottom position)
- turn the hand wheel, until the value XXX begins to change
- turn the hand wheel at the value of the bottom position angle (160 on the panel)
- depress the pushbutton E
- the display will show 2 XXX (value of the top position)
- turn the hand wheel, until the value XXX begins to change
- turn the hand wheel at the value of the top position angle (460 on the panel)
- depress the pushbutton P 2x (return to the sewing mode)
- tread shortly forward the pedal (memory entry)
12.5.2 Changes of setting parameters of stop motor setting considering original producer setting
Parameter Parameter
No value
111 - Max. revolutions (according to a type of machine)
170 - Reference position
171 1 160 Lower position
2 460 Upper position
190 300 Switch on angle of thread trimmer (210
°)
202 120 Delay of start run after switch off the signal foot
210 200 Stopping time for fancy bar
213 5 Time off full power of backtacking
12.6 Stop motor setting S359 600052 XX - EFKA VD 552/6F82FA
12.6.1 Setting position reader
Positions are set by means of discs with cut outs directly in positon reader.
Setting of the lower position:
- dismount the guard of the position reader
- switch on the mains switch
- tread shortly pedal forward (the machine stops in the needle lower position)
- switch off the mains switch
- turn the beginning of the recess 1 of the overlapping disks in such a way, so that the machine stops with the needle in the
position of 3 mm behind the bootom dead center
- check up in repeating the procedure
Setting of the top position of the thread lever:
- tread the pedal rearward (the machine stops in the needle upper position)
- switch off the mains switch
- turn the beginning of the recess 2 in such a way, so that the machine stops with the thread lever in the top dead centre
- check up in repeating the procedure.