Instruction manual

8
10. Composition and assembly of the thread stand (Fig. 15, 16)
Assemble the thread stand and mount it into the hole in the plate so that its arms would be parallel to the longer edge of a
table top.
Each thread may be fed only through one hole in the thread stand arm.
11. Preparation of the machine for sewing
Inspect carefully the machine, clean and try it, if it turns easily and if it is correctly adjusted.
Fill with oil the oil tank for lubricating the hook and for the central wick-feed lubrication  the lubricating spots are marked
with red colour on the machine (part A, par, 7.2 - Fig 12, 13).
For lubricating, use oil ESSO SP-NK 10 or an oil with an equivalent quality. Connect the machine to the mains.
With the sewing drives with three-phase motor, check up the direction of the motor rotation through a short-run connecting
of the motor switch. The direction of the machine rotation is marked with an arrow on the belt guard.
In case of an incorrect direction of rotation, inverse mutually two phases in the mains plug. Before utilizing the machine in
full power, let run it for some minutes on low speed.
Fig. 15 Fig. 16