Full Product Manual

Page 11

E.) Installing the Unit (Continued)

Connecting the control box to the electrical source

6.) A small ﬂat head screw driver is required for installation. Once the

wiring is run through the conduit, attach the wires to the terminal block

located on the inner left side of control box. Attach the black wire to the

terminal marked LINE, attach the white wire to the terminal marked

NEUTRAL, and ﬁnally attach the green wire to the terminal marked

GROUND. Refer to the wiring diagram located in this section. Optional

wire clamp is provided to help secure the wire in place. Attach the face

plate to the enclosure and insure that the installed wiring does not interfere

with the circuit board attached to the face plate.

  All trademark names are property of their respective companies.

Connecting the Electrode Cable

7.) Connect the two electrode wires (inside the gray colored jacket) to the electrode connectors on the bottom

of the electrode jar. It does not matter what wire is connected to the electrode terminals. Make sure they do not

touch each other. These connectors are weatherproof and there is no need to cover them.

To ensure the maximum NEMA 4 rating,

please use the included screws (Enclosure Lid

Securing Screws (2)) in the top right and

bottom right holes on the lid of the unit once

it has been shut and locked in place with the

lid latch.