Full Product Manual

Page 10

E.) Installing the Unit

(Continued)

Connecting the timer box to the control box

4.) Below is an example of connecting the control box to a timer box. In this example an Intermatictm timer

box is used. Although most timer boxes are similar they are not exactly the same, please take care when using

the provided information.

230 VAC Operation:

Connect the black (3 stranded) wire cable to the 230 VAC timer box by splicing

the 3 wires and connecting the black and white wires to the LOAD side on the

timer box. It makes no diﬀerence which colored wire goes to the two load screws.

Connect the green wire to GROUND. When installed properly, the unit should

come on and oﬀ when the pool pump goes on and oﬀ.

115 VAC Operation:

Connect either the white wire or the black wire to the LOAD side on the timer box. It

makes no diﬀerence which colored wire goes to the two load screws. Connect the

green wire to ground. When installed properly, the unit should come on and oﬀ when

the pool pump goes on and oﬀ.

Connecting the pump motor to the control box

5.) Disconnect the back plate to the motor where the electrical

connections are. You will notice two connections where the

power source comes in and is connected. Connect the

MineralPURE's power cable (black, white and green) to the

same as the motor's connections. If connected properly, the

unit should come on and oﬀ with the motor.