Instruction manual
56
Batteries
CTX 3030 Instruction Manual
Power LED Indicator
Battery LED Indicator
Figure 37 – BC 10 Front Panel
Battery LED
OFF No battery plugged into charger
Slow ashing green Battery is charging, normal operation
Fast ashing red Charger error detected
Steady on green Battery is fully charged
Power LED
OFF No input power, charger is OFF
Steady on green Correct input voltage, charger is ON, normal operation
Fast ashing red Incorrect input voltage, charger cannot operate
Table 38 – BC 10 battery charge and power status information
Recharge the Lithium-Ion Battery Pack
1. Remove the battery pack from the detector and place it into the charger unit,
ensuring that the connector pins line up.
Figure 39 – Recharge the Li-Ion battery
2. Insert the plug pack or car charger cable connector into the socket on the right
hand side of the charger unit.
3. Plug the other end of the cable into the wall or car socket and turn on the switch.
Leave the unit to fully recharge.
The green indicator light will stop ashing and remain static when the battery is
fully charged (up to four hours).