Instruction manual

48
49
Auto Accept Mode
When a target is detected in Auto Accept
Mode, the Discrimination Pattern will be
automatically modied to accept the FE-CO
coordinates of that target.
To Auto Accept the target:
1 Place the target on the ground
2 Press the Right Shift button until the Auto
Accept Edit Mode is selected
3 Swing the coil several times over the
desired target until the detector accepts
it by clearing an area in the Smartnd
Window. If you have more than one target,
repeat the procedure for each one
4 Press the Detect button (or QuickMask
button if you wish to load the pattern into
QuickMask) once you have nished editing
5 Answer ‘Yes’ to the dialogue box to return
to the Pattern/Digital (or QuickMask) Screen
with your new Discrimination Pattern
loaded into Smartnd
Discrimination Menu
E-Trac needs to detect the target consistently
to accept it into the Smartnd Disc. Pattern.
Creating a Discrimination Pattern
using Auto Accept:
Fill in the Smartnd Window:
Press the Left Shift button until the ‘All
Pattern’ Edit Frame is selected. Press the
Accept/Reject button twice to reject the
entire Discrimination Pattern. This lls in the
Smartnd Window, rejecting all targets
and preparing the Window for learning a
new target.
Change the size of the cursor:
Press the Left Shift button to change the
Edit Frame size (Small, Medium, Large or
All Pattern).
CAUTION: Pressing the Menu Button
while in Edit will take you back to the
Discrimination Menu and all changes
made in Edit will be lost.
Auto Latch Mode
The Auto Latch Mode automatically selects
the FE-CO coordinates of a detected target.
This allows you to either accept or reject the
target from the Discrimination Pattern using
the Accept/Reject button.
To Auto Latch the target:
1 Place the target on the ground
2 Press the Right Shift button until the Auto
Latch Edit Mode is selected
3 Swing the coil several times over the
desired target until the detector conrms
the FE-CO coordinates
4 Press the Accept/Reject button once to
reject those coordinates from the Smartnd
Discrimination Pattern, press twice to
accept. If you have more than one target,
repeat the procedure for each one
5 Press the Detect button (or QuickMask
button if you wish to load the pattern into
QuickMask) once you have nished editing
6 Answer ‘Yes’ to the dialogue to return to
the Pattern/Digital (or QuickMask) Screen
with your new Discrimination Pattern
loaded into Smartnd
Tip: Changing the Trash Density setting (pp.
72–3) from High to Low can stabilise the
FE-CO coordinates of a detected target while
using any ‘Auto’ Edit Modes.
Creating a Discrimination Pattern
using Auto Latch:
Clear the Smartnd Window:
Press the Left Shift button until the ‘All
Pattern’ Edit Frame is selected. Press the
Accept/Reject button once to accept the
entire Discrimination Pattern. This clears the
Smartnd Window, accepting all targets
and preparing the window for learning a
new target.
Change the size of the Edit Frame:
Press the Left Shift button to change the
Edit Frame size (Small, Medium, Large or All
Pattern). A Large frame will accept a larger
area of the Discrimination Pattern as a target
is detected. A Small frame will accept a
smaller area of the Discrimination Pattern,
but slightly altered or damaged targets may
be ignored.