Instruction manual

26
27
Layout Summary of the Detection Screens
When the detector is turned On for the rst
time, the Pattern Screen will appear on the
LCD and E-Trac is ready to begin detecting.
Target information is presented via visual and
audio prompts. An introduction to the most
common elements of the Detection Screens
is below:
Battery Icon
Indicates the present
battery charge available.
The Battery Icon will ash
when the battery is low
(pp. 84–5)
Backlight Icon
Displayed when the
Backlight is On.
USB Icon
Displayed when the
detector is connected
to a PC via a USB cable
(p. 80).
Minelab User Mode
The Minelab logo
is displayed when a
Minelab User Mode is
selected (pp. 38–41).
User Mode Number
A boxed number
species which User
Mode is being used (pp.
38–41).
User Mode Modied
The ag icon is displayed
when a User Mode has
been modied but not
saved (pp. 38–41).
Accept Icon
Noties you that you
have used the Accept/
Reject button to accept
the detected target’s
coordinates.
Manual Sensitivity
Gauge
The left bar, and the
number at the top, is
the user-set Sensitivity.
The right bar is the
‘suggested’ Sensitivity
(pp. 54–6).
Auto Sensitivity
Animation
Displayed when Auto
Sensitivity is operating
(pp 54–6).
My User Mode Icon
This icon is displayed
when one of your User
Modes is selected (pp.
38–41).
Ferrous-Conductivity
Numbers
The area where FE-CO
numbers of an accepted
target are displayed (p.
21).
Reject Icon
Noties you that you
have used the Accept/
Reject button to reject
the detected target’s
coordinates.
Auto Sensitivity Gauge
The left bar, and the
number at the top, is
the user-set Sensitivity.
The right bar is the
‘suggested’ Sensitivity
(pp. 54–6).
Target Crosshair
Will appear when an
accepted target is
detected, indicating the
Ferrous and Conductivity
coordinates of that target
(p. 21).
Depth Gauge
Represents the
approximate depth of
a target beneath the
coil. The range, from top
to bottom, is 0–30cm
(0–12”) (p. 25).