User's Manual
Table Of Contents
- Getting Started
- Quick Start
- Controls
- Display
- Battery
- Bluetooth® Headphones
- Coils
- High Performance Automatic Operation
- Intelligent Automatic Operation
- Manual Procedures and Settings
- Manual Sensitivity
- Noise Cancel
- Ground Balance
- Advanced Concepts
- Identifying the Source of Detector Noise
- Double‑D Modes
- Threshold Tone
- Troubleshooting
- Errors
- Coil Overload
- General Troubleshooting
- Care and Safety
- Specifications
18
CONTENTS
Ground Balance Procedure (Continued)
Conductive (Salty) Ground `
7. Change to a Double-D coil.
Turn off the detector and change to a Double-D coil
(see "Changing the Coil" on page 9).
8. Turn the detector on.
Turn the detector back on.
9. Ensure the Double-D mode is set to
Conductive Ground Cancel.
Long press for at
least 2.5 s
To set the Double-D mode to Conductive Ground Cancel, long
press the Noise Cancel button for at least 2.5 seconds.
10. Quick-Trak.
Perform the Quick-Trak procedure (page 16).
11. Adjust the sensitivity.
Adjust the sensitivity level (page 12).
Swing the coil close and parallel to the ground when adjusting
the sensitivity in order to remove ground noise.
`Begin detecting.