User's Manual

Min

olo

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

NOTE 1: Any changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user's authority to operate the equipment.

FCC Radiation Exposure Statement:

Note 1: This device meets the government's requirements for exposure to radio waves. The

guidelines are based on standards that were developed by independent scientific

organizations through periodic and thorough evaluation of scientific studies. The standards

include a substantial safety margin designed to assure the safety of all persons regardless of

age or health. The SAR limit of USA (FCC) is 1.6 W/kg averaged. Device types: UT33 Tag (FCC

ID: N73-UT33) has also been tested against this SAR limit. SAR information on this and other

pad can be viewed on line at http://www.fcc.gov/oet/ea/fccid/. Please use the device

FCC ID number for search. This device was tested simulation typical 10mm to body. To

maintain compliance with FCC RF exposure requirements, use accessories should maintain a

separation distance between the user's bodies mentioned above, the use of belt clips,

holsters and similar accessories should not contair metallic components in its assembly. the

use of accessories that do not satisfy these requirements may not comply with FCC RF

exposure requirements, and should be avoided. Body-worn accessories that do not meet

these requirements may not comply with RF exposure requirements and should be avoided.

Use only the supplied or an approved antenna.

Note 2: Any modifications made to the module will void the Grant of Certification, this

module is limited to OEM installation only and must not be sold to end-users, end-user has

no manual instructions to remove or install the device, only software or operating procedure

shall be placed in the end-user operating manual of final products.

Note 3: Additional testing and certification may be necessary when multiple modules are

used.

Note 4: The module may be operated only with the antenna with which it is authorized. Any

antenna that is of the same type and of equal or less directional gain as an antenna that is

authorized with the intentional radiator may be marketed with, and used with, that

intentional radiator.

Note 5: For all products market in US, OEM has to limit the operation channels in CH1 to

CH11 for 2.4G band by supplied firmware programming tool. OEM shall not supply any tool