User's Manual

Min

olo

2.2 List of applicable FCC rules

FCC Part 15.247, FCC Part 2.1093

2.3 Specific operational use conditions

This product is a Limited Single Modular transmitter; Use only the supplied or an

approved antenna.

2.4 Limited module procedures

Mine Site Technologies Pty Ltd will retain control over the final installation of the

modular such that compliance of the end product is assured. In such cases, an

operating condition on the limit modular approval for the module must be only

approved for use when installed in devices produced by a specific manufacturer. If

any hardware modify or RF control software modify will be made by host

manufacturer. C2PC or new certificate should be apply to get approval, if those

change and modification made by host manufacturer not expressly approved by the

party responsible for compliance ,then it is illegal.

2.6 RF exposure considerations

This module certified that complies with RF exposure requirement under 0mm to

body.

2.8 Label and compliance information

N73-

2.9 Information on test modes and additional testing requirements

Contact Mine Site Technologies Pty Ltd will provide stand-alone modular transmitter

test mode. Additional testing and certification may be necessary when multiple

modules are used in a host.

2.10 Additional testing, Part 15 Subpart B disclaimer

To ensure compliance with all non-transmitter functions the host manufacturer is

responsible for ensuring compliance with the module(s) installed and fully

operational. For example, if a host was previously authorized as an unintentional

radiator under the Suppli Declaration of Conformity procedure without a

transmitter certified module and a module is added, the host manufacturer is

responsible for ensuring that the after the module is installed and operational the

host continues to be compliant with the Part 15B unintentional radiator requirements.

Since this may depend on the details of how the module is integrated with the host,

Mine Site Technologies Pty Ltd shall provide guidance to the host manufacturer for

compliance with the Part 15B requirements.