User's Manual
Table Of Contents
- Table of Contents
- Statement
- General Information
- Physical map
- Component function
- Performance index
- Accessories
- General attention
- Warranty conditions
- FCC StatementThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna.—Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure StatementThis device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with Part 15 of the FCC RF Rules. This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and consider removing the no-collocation statement.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Caution! Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
MineSiteTechnologiesPtyLtd
Warranty conditions
For any defect, in the judgment of our technician, caused under
normal use, we are responsible for repairing free of tages one year
commencing from the date of purchase at the discretion of our
company. A valid warranty card and original purchase invoice must
be presented upon request of warranty service.
This warranty card shall not apply to the product if
(1) It has explicitly modified or repaired in any wan by persons other
than technicians of this company, or
(2) It has been damaged through misuse, malicious acts,
negligence, and inflow of any liquid, accident or natural calamities.
No alteration to this warranty card will be allowed
The warranty terms and conditions will be subjected to change with
prior notice.
Please retain you proof of purchase for warranty service.
7