Operator's Manual

Maintenance Menu Configuring the TM80/TM70
13 - 8 TM80/TM70 Telemetry Monitor Operator’s Manual
3. Tap to exit the [Network] menu.
13.2.5.1 Configuring IP Settings
The TM80 provides two ways to get IP address: Dynamic Host Configuration Protocol
(DHCP) and Static IP address.
To configure IP settings:
1. In the [Network] menu, tap [IP Address Setup].
2. Select the options described in the following table.
Options Action Description Applicable model
IP Address Setup Select to access the IP Setting
menu.
Refer to "Configuring IP
Settings" on page 13 - 8
for details.
TM80
WLAN Setup Select to access the WLAN Set-
ting menu.
Refer to "Configuring
WLAN Settings" on page
13 - 9 for details.
TM80
Connect CMS Select to access the Connect CMS menu. TM80&TM70
Wireless Setup Select the desired wireless band. Refer to "Selecting a WiFi
Band" on page 13 - 11 for
details.
TM80(for TM70,
refer to "Configur-
ing WMTS Setting"
on page 13 - 16”
EAP Certificate Import desired certificates and
delete certificates from the
TM80.
Refer to "EAP Certificate
Management" on page 13
- 12 for details.
TM80
NOTE
• The design, installation, reconstruction and maintenance of the wireless
network’s distribution shall be performed by authorized service person-
nel of Mindray.
• The existence of obstacles (such as wall) will exert impact on data trans-
ferring or even cause network interruption.
• The Central Monitoring System is capable of connecting up to 32 Telem-
etry Monitors via the wireless network.