Operator's Manual

Monitoring with the TM80/TM70 at the CMS NIBP Monitoring
TM80/TM70 Telemetry Monitor Operator’s Manual 12 - 29
12.13 NIBP Monitoring
At the CMS, you can view and change NIBP settings in the [NIBP] menu.
Select the NIBP digital area on the ViewBed screen of the CMS to enter the [NIBP] menu.
12.13.1 Measurement Limitations
See BP10 NIBP Module Operator’s Manual (P/N 046-011008-00) for details.
12.13.2 Changing NIBP Alarm Properties
1. In the [NIBP] menu, select the [Alarm] tab.
2. Set the desired alarm properties.
For the default alarm properties, See "Factory Default Parameter Alarm Settings" on
page 12 - 3.
12.13.3 Changing NIBP Settings
1. In the [NIBP] menu, select the [Setup] tab.
2. Set [Interval].
12.13.4 NIBP Display
The NIBP area displays numerics, as shown below:
1. Parameter label
2. Systolic pressure
3. Diastolic pressure
4. Diastolic pressure high limit
5. Mean pressure high limit
6. Mean pressure low limit
7. Mean pressure obtained after the measurement and cuff pressure obtained during
the measurement
8. Diastolic pressure low limit
9. Systolic pressure low limit
10. Systolic pressure high limit