Operator's Manual

Monitoring with the TM80/TM70 at the CMS ST Monitoring
TM80/TM70 Telemetry Monitor Operator’s Manual 12 - 17
12.9.2 Entering the ST Tab
1. Select the ECG digital area or waveform area to enter the [ECG] menu on the
ViewBed screen of the CMS.
2. Select the [ST] tab.
12.9.3 Changing ST Alarm Properties
1. From the [ST] tab, select the [Alarm] section.
2. Set the desired alarm properties.
For the default alarm properties, See "Factory Default Parameter Alarm Settings" on
page 12 - 3.
12.9.4 Changing ST Settings
1. From the [ST] tab, select the [Setup] section.
2. Set the desired items.
Options or Buttons Description Default Setting
ST Analysis Enables or disables ST analysis. Off
ST Segment Select whether or not to display the ST
segments in the waveform area.
Auto
Show Markers Select whether or not to display the ISO
point, J point, and ST point mark do not
display on the ST segments.
Off
Define ST Point Select to display the [Define ST Point]
menu.
See "Adjusting ST Measurement
Points" on page 12 - 18 for details.
This button is only available when [ST Analysis] is set to [On].
* The factory default settings are in bold.