Operator's Manual

Monitoring NIBP (Optional) Interactions after Pairing a TM80/TM70 with a BP10
TM80/TM70 Telemetry Monitor Operator’s Manual 10 - 7
10.5 Interactions after Pairing a TM80/TM70 with a
BP10
10.5.1 Overview of Interactions
Once a TM80/TM70 is paired successfully with a BP10, the interactions proceed as shown
below.
10.5.2 Operating the BP10 via the TM80/TM70
When the TM80/TM70 is paired successfully with the BP10, you can tap anywhere in the
NIBP parameter area on the main screen of the TM80/TM70 to access the [NIBP] menu.
In the [Actions] section of the [NIBP] menu, you can:
■ Tap [Start] to start NIBP measurement at the BP10.
■ Tap [Stop] to stop an ongoing NIBP measurement at the BP10.
■ Tap[ NIBP STAT] to start the series measurement in continuous mode at the BP10.
■ Tap [Stop All] to cancel the series measurement in Auto, Sequence, or ABPM mode
at the BP10.
Action At the TM80/TM70 At the BP10
Start NIBP measurement Yes Yes
Stop NIBP measurement Yes Yes
Stop All NIBP measurements Yes Yes
NIBP STAT Yes Yes
Set initial pressure Yes No
Set NIBP measurement mode Yes No
Configure settings related to [Auto]
measurement mode
Yes No
Configure settings related to NIBP
[Sequence] measurement mode
Yes No
Set NIBP settings related to NIBP [ABPM]
measurement mode
Yes No
Set venipuncture No Yes
Set the cuff pressure for venipuncture No Yes