Operator's Manual

Monitoring NIBP (Optional) Pairing the TM80/TM70 with the BP10

TM80/TM70 Telemetry Monitor Operator’s Manual 10 - 3

10.2.2 System Responses after Successful Pairing

Once a TM80/TM70 is paired successfully with a BP10, the following system responses

occur:

■ The icon will be changed to in the top-right corner of the TM80/TM70’s

screen. Besides, the appears in the top-right corner of the BP10.

■ The status of the BP10 which is paired successfully with the TM80/TM70 is

displayed as [Connected]. Besides, the “Pairing Successful” displays in the BP10’s

message area for about 10 seconds.

■ When NIBP measurement mode is set to [ABPM] at BP10 and the BP10 is paired

successfully with the TM80/TM70, the wireless seup confirmation message “Select

Yes to continue Patient in BP10. Select No to continue Patient in Telemetry.” will

display on the main screen of the TM80/TM70.

◆ [Ye s ]: Patient-related settings comes from BP10 and ongoing NIBP

measurement for current patient will not stop.

◆ [No]: Patient-related settings at BP10 comes from the TM80/TM70. Besides,

NIBP measurement for the patient monitored by BP10 will stop and the data

history related to this patient will be cleared at BP10.

◆ If neither [Ye s ] nor [No] is selected, the wireless setup confirmation message

will disappear in three minutes. Besides, the “Pairing failure” message will be

displayed in the prompt message area of the TM80/TM70 . The “MPAN

Disconnected” message is displayed in the message area of the BP10. In this

WARNING

• Do not pair a TM80/TM70 with an undesired BP10. If a TM80/TM70 is

paired with an undesired BP10, the patient category may be not applica-

ble for the patient and the measured NIBP data may be incorrect.

NOTE

• Make sure that you have selected the correct BP10 to pair it with the

TM80/TM70.

• If you pair a TM80/TM70 with a BP10 when NIBP measurement mode is

set to [ABPM] at BP10, the system responses after successful pairing are

slightly different from that when the NIBP measurement mode is set to

[Manual], [Auto], or [Sequence]. For the differences, see "System

Responses after Successful Pairing" on page 10 - 3.