Operator's Manual

Configuring the TM80/TM70 Maintenance Menu
TM80/TM70 Telemetry Monitor Operator’s Manual 13 - 9
3. Tap [Confirm] to apply the settings and exit the [IP Address Setup] menu.
13.2.5.2 Configuring WLAN Settings
1. In the [Network] menu, tap [WLAN Setup].
2. Select the options described in the following table.
Options Description Settings*
DHCP Allows an authorized user to select the
way to get the IP address. When enabled,
the IP address is automatically assigned.
On, Off
The following three options are only enabled when [DHCP] is set to Off.
IP Address Select to input the IP address. Range: 1 to 255
Factory default: 192.168.0.100
Subnet Mask Select to input the subnet mask. Range: 1 to 255
Factory default: 255.255.255.0
IP Gateway Select to input the IP gateway address. Range: 1 to 255
Factory default: 192.168.0.254
* The factory default settings are in bold.
Options Description Settings*
Network Name Select to input the name for the desired
wireless network.
N/A
Security Type Configure the wireless network security
type.
If [WPA2-PSK] is selected, you need to
configure [Network Password].
The [WPA/WPA2 EAP] option is displayed
only when [WiFi Band] is set to [5G].
If [WPA/WPA2 EAP] is selected, you need
to configure [Network Password] and
additional items such as [EAP Method]
and [Authentication]. You also need to
import the desired certificate into the
TM80 before you can select a certificate.
For how to manage certificates, refer to
"EAP Certificate Management" on page
13 - 12.
WPA2-PSK, WPA/WPA2 EAP
* The factory default settings are in bold.