User's Manual

5 - 3
4. Select Export Data.
5.4 Deleting Patient Data
To delete the data of discharged patients, follow this procedure:
1. Access the Discharged Patients dialog box by either of the following ways:
◆ Select the Discharged Patients quick key.
◆ Select the Main Menu quick key → from the Patient Management column select Discharged
Patients.
2. From the patient list select desired patients.
3. Select Delete.
5.5 Stopping a Parameter Measurement
To stop monitoring a parameter, follow this procedure:
1. Remove corresponding sensor from the patient.
2. Disconnect the sensor from the patient cable.
3. Disconnect the patient cable from the parameter module.
5.6 Discharging a Patient
Before monitoring a new patient, discharge the previous patient. The technical alarms are reset, and monitor
settings returns to their defaults. For more information, see 24.3Setting Default Patient Category.
After a patient is discharged, the monitor automatically admits a new patient.
WARNING
• Always discharge the previous patient before starting to monitor a new patient. Failure to do so can
lead to data being associated with the wrong patient.
To manually discharge a patient, use any of the following methods to access the Discharge Patient dialog:
■ Swipe down the touchscreen with two fingers.
■ Select the Discharge Patient quick key.
■ Select the patient information area at the top left corner of the screen→ Discharge Patient.
■ Select the Patient Management quick key → Discharge Patient.
■ Select the Main Menu quick key → from the Patient Management column select Discharge.
Select a button in the Discharge Patient dialog:
■ Print End Case Report: prints the end case report when the patient is discharged.
■ Discharge: clears the waveform data of the current patient. The monitor loads the default configuration
and goes to the standby mode. The current patient becomes a discharged patient.
■ Clear Patient Data: discharges the current patient and clears the waveform data. The monitor still uses the
current configuration and does not go to the standby mode. The current patient becomes a discharged
patient.