User's Manual

B - 4
WARNING
• The device is configured with a wireless network connector to receive wireless signal. Other devices
may interfere with this device even though they meet the requirements of CISPR.
B.2 Radio Regulatory Compliance
RF parameters
The radio device used in this product is in compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU.
This device complies with part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to
the condition that this device does not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
Recommended separation distances between portable and mobile RF communications equipment and the device
The device is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The
customer or the user of the device can help prevent electromagnetic interference by maintaining a minimum distance
between portable and mobile RF communications equipment (transmitters) and the device as recommended below,
according to the maximum output power of the communications equipment.
Rated maximum
output power of
transmitter (W)
Separation distance in meters (m) according to frequency of the transmitter
150 kHz to 80 MHz 80 MHz to 800 MHz 800 MHz to 2.7 GHz
0.01 0.12 0.12 0.23
0.1 0.38 0.38 0.73
1 1.20 1.20 2.30
10 3.80 3.80 7.30
100 12.00 12.00 23.00
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres
(m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output
power rating of the transmitter in watts (W) according to the transmitter manufacturer.
Note 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
Note 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects and people.
d1.2P=
d1.2P=
d2.3P=
Type of Radio
IEEE 802.11b/g/n (2.4G) IEEE 802.11a/n (5G)
Operating Frequency ETSI: 2.4 GHz to 2.483 GHz
FCC: 2.4 GHz to 2.483 GHz
MIC: 2.4 GHz to 2.495GHz
KC: 2.4 GHz to 2.483 GHz
ETSI: 5.15 GHz to 5.35 GHz, 5.47 GHz to 5.725 GHz
FCC: 5.15 GHz to 5.35 GHz, 5.725 GHz to 5.82 GHz
MIC: 5.15GHz to 5.35 GHz
KC: 5.15 GHz to 5.35 GHz, 5.47 GHz to 5.725 GHz,
5.725 GHz to 5.82 GHz
Modulation Mode DSSS and OFDM OFDM
Output Power < 30 dBm (peak power)
< 20 dBm (average power)