User Manual

Nonin SpO
2
Module Specifications Performance Specifications
16 - 28 0070-10-07XX-02 Panorama™ Operating Instructions
16.11.3 Electromagnetic Compatibility
The following section describes the electromagnetic compatibility of the Nonin SpO
2
device.
The Nonin SpO
2
module meets the requirements of:
• IEC 60601-1-2
• ISO 9919
TABLE 16-13
GUIDANCE AND DATASCOPE CORP. DECLARATION - ELECTROMAGNETIC EMISSIONS
It is important that the Nonin SpO
2
module is used in the electromagnetic environment specified in
the following table.
EMISSIONS
TEST COMPLIANCE ELECTROMAGNETIC ENVIRONMENT - GUIDANCE
RF emissions
CISPR 11
Group 1 The Nonin SpO
2
module uses RF energy only for its
internal function and external data transmission.
However, its RF emissions are very low and are not likely
to cause any interference in nearby electronic equipment.
RF emissions
CISPR 11
Class B The Nonin SpO
2
module is suitable for use in all
establishments other than domestic establishments and
those directly connected to the public low-voltage power
supply network that supplies buildings used for domestic
purposes.
Harmonic
emissions IEC
61000-3-2
N/A
IEC
61000-3-3
Voltage
fluctuations/
Flicker
emissions
N/A
TABLE 16-14
GUIDANCE AND DATASCOPE CORP. DECLARATION - ELECTROMAGNETIC IMMUNITY
It is important that the Nonin SpO
2
module is used in the electromagnetic environment specified in
the following table.
IMMUNITY
TEST
IEC 60601
TEST LEVEL
COMPLIANCE
LEVEL
ELECTROMAGNETIC
ENVIRONMENT - GUIDANCE
Electrostatic
discharge (ESD)
IEC 61000-4-2
±6 kV contact
±8 kV air
±6 kV contact
±8 kV air
Floors should be wood, concrete or
ceramic tile. If floors are covered with
synthetic material, the relative humidity
should be at least 30%.
Electrical fast
transient/burst
IEC 61000-4-4
N/A N/A* Mains power quality should be typical
of a commercial or hospital
environment.
* The Nonin SpO2 module receives power from the Telepack which operates only from an internal
battery.