User Manual

Table Of Contents
Panorama™ Operating Instructions 0070-10-07XX-02 16 - 11
Performance Specifications Panorama Central Station and Panorama Telemetry Server
TABLE 16-2
GUIDANCE AND DATASCOPE CORP. DECLARATION - ELECTROMAGNETIC IMMUNITY
The Panorama Central Station, Telemetry Server, and Panorama Wireless Transceiver is intended for
use in the electromagnetic environment specified below. The customer or the user of the Panorama
Central Station and Telemetry Server should assure that it is used in such an environment.
IMMUNITY
TEST
IEC 60601
TEST LEVEL
COMPLIANCE
LEVEL
ELECTROMAGNETIC
ENVIRONMENT - GUIDANCE
Electrostatic
discharge (ESD)
IEC 61000-4-2
±6 kV contact
±8 kV air
±6 kV contact
±8 kV air
Floors should be wood, concrete or
ceramic tile. If floors are covered with
synthetic material, the relative humidity
should be at least 30%.
Electrical fast
transient/burst
IEC 61000-4-4
±2 kV for power
supply lines ±1
kV for input/
output lines
± 2 kV for power
supply lines
± 1 kV for input/
output lines
Mains power quality should be typical
of a commercial or hospital
environment.
Surge IEC
61000-4-5
±1 kV
differential
mode ±2 kV
common mode
± 1 kV
differential mode
± 2 kV common
mode
Mains power quality should be typical
of a commercial or hospital
environment.
Voltage dips,
short
interruptions and
voltage
variations on
power supply
input lines IEC
61000-4-11
<5% U
T
(>95%
dip in U
T
) for
0,5 cycle
40% U
T
(60%
dip in U
T
) for
5 cycles
70% U
T
(30%
dip in U
T
) for
25 cycles
< 5% U
T
(>95%
dip in U
T
) for 5
sec
<5% U
T
(>95%
dip in U
T
) for 0,5
cycle
40% U
T
(60%
dip in U
T
) for
5 cycles
70% U
T
(30%
dip in U
T
) for
25 cycles
< 5% U
T
(>95%
dip in U
T
) for
Mains power quality should be typical
of a commercial or hospital
environment. If the user requires
continued operation during power
mains interruptions, it is recommended
that the device be powered from an
uninterruptible power supply or a
battery.
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
3 A/m 3 A/m Power frequency magnetic fields
should be at levels characteristic of a
typical location in a typical commercial
or hospital environment.
U
T
is the a.c. mains voltage prior to application of the test level.
NOTE: Panorama Central Station, Telemetry Server, and
Panorama Wireless Transceiver, that are rack mounted,
shall be powered down prior to cable and/or Panorama
Licensing Key attachment or disconnect.