User Manual

Table Of Contents
Paging Tab Paging Tab (Optional)
15 - 6 0070-10-0690-01 Panorama™ Operating Instructions
3. Select a tile number.
NOTE: The list box will only include patient tiles that are not
currently assigned to the selected pager.
NOTE: A patient tile number can be assigned to a maximum of 10
pagers.
4. Accept or reject the selections made in the list box.
•The Done button accepts the selection, closes the dialog box, and updates the
Paging tab list box.
•The Cancel button discards the selection, closes the dialog box, and returns to the
Paging tab.
5. Repeat steps 2 - 4 to continue adding patient tiles to the selected pager, if necessary.
NOTE: Multiple tile assignments will be separated by a comma (,)
in the Tile column.
15.2.4 Adding All Patient Tiles to a Pager
To assign all available patient tiles to a pager:
1. From the Paging tab list box, select a pager.
2. Select the Add All Tiles button. The Are you sure you want to Add All Tiles?
question dialog box is displayed.
•The Yes selection confirms the selection, closes the question dialog box, and updates
the Tile column in the Paging tab list box.
•The No selection cancels the selection, closes the confirmation dialog, and returns to
the Paging tab list box.
15.2.5 Removing a Patient Tile Assignment
To remove an existing tile assignment from a pager:
1. From the Paging tab list box, select a pager.
2. Select the Remove Tile button. The Tile Number dialog box (shown in FIGURE 15-4) is
displayed. The number of tiles that are displayed is dependent on the number of patient
tiles assigned to the selected pager.
3. Select a patient tile.
4. Accept or reject the selections made in the list box.
•The Done button accepts the selection, closes the dialog box, and returns to the
Paging tab where the list box updates are displayed.
•The Cancel button discards the selection, closes the dialog box, and returns to the
Paging tab.
15.2.6 Removing All Patient Tiles from a Pager
To remove all patient tiles assignments from a pager:
1. From the Paging tab list box, select a pager.