User Manual

Table Of Contents
Panorama™ Operating Instructions 0070-10-0690-01 7 - 49
Views Disclosure Tab
Right Arrow Button
Select the right arrow button to view the ST data for the next event second.
Done Button
Select the Done button to close the Full Disclosure Zoom In ST dialog.
7.4.2.5 Comments Dialog Box (Optional)
With the addition of system-wide paging, a paging notification can be sent to clinicians to
alert them that a specific event type has occurred. If a page was sent for a selected event in
the Waveforms view, an asterisk (*) will appear beside the event in the event description
area (shown in FIGURE 7-18). The paging information related to the event can be viewed by
selecting the Comments sidebar button. The Comments dialog box will display either a
Page Sent or a Page Failed message. If the selected event does not have an asterisk
beside the event description, this indicates that a page has not been sent for the selected
event. In this case, the Comments sidebar button will be disabled.
7.4.2.6 Sidebar Buttons
The Waveforms view may contain up to six sidebar buttons.
Zoom Out
Select the Zoom Out sidebar button to return to the Compressed view of the Disclosure
tab.
Lead
Select the Lead sidebar button to cycle through each of the waveforms in the ordered set.
The Lead sidebar button is not available when using a:
Telepack device with a 3 or 5-wire lead set
Telepack with Nonin SpO
2
module with a 3-wire lead set
All ECG
Select the All ECG sidebar button to access the All ECG mode of the Disclosure tab. When
the All ECG button is white, this indicates the Disclosure tab is in the All ECG mode. The
Waveforms view remains in the All ECG mode until the All ECG sidebar button is
selected again. The All ECG sidebar button is not available when using a:
Telepack device with a 3 or 5-wire lead set
Telepack with Nonin SpO
2
module with a 3-wire lead set
NOTE: If a 5-wire or 12-lead set was previously used for the
selected patient, the All ECG sidebar push button will
always be enabled.