User Manual

Table Of Contents
Events Tab Views
7 - 30 0070-10-0690-01 Panorama™ Operating Instructions
2. To enter the end time, follow steps 2, 3, and 4 from the previous section (entering a Start
Time).
7.3.3.4 Parameter Filters
By selecting specific parameters, the Events tab will only display the events that contain the
chosen parameter. Parameter filters can be configured for physiological and technical
events. The physiological events listed are dependent on the assigned monitoring device and
the technical events listed are dependent on the ECG lead wire set currently in use.
Accessing the Parameter Filter
To access the Parameter Filter (shown in FIGURE 7-17), select the Param sidebar button
from the All Events view. By default, the physiological events are shown first. If any
previously selected parameters were specified, they will be displayed in the Event Filter text
box beside the Param: label.
FIGURE 7-17 Parameter Event Filter View
Configuring a Parameter Filter
To configure a parameter filter:
1. If a technical event filter is needed, select the Tech button.
NOTE: By default, the physiological events are displayed when the
Param sidebar is selected.
2. Move/remove the selected events by using any of the buttons described in the following
table:
BUTTON FUNCTION
Remove All Removes all the events listed in the Selected Events list box and
from the Event Filter text box.
Add/Right Arrow Adds the selected event to the Selected Events list box, and to the
Event Filter text box.
Remove/Left Arrow Removes the chosen event from the Selected Events list box and
from the Event Filter text box.
NOTE: A maximum of five physiological and/or technical events
may be added to the Selected Events list at one time.