User Manual

Alarm Responses Tab (Patient) Patient Alarm Functions
6 - 12 0070-10-0690-01 Panorama™ Operating Instructions
6.3 Alarm Responses Tab (Patient)
The Alarm Responses tab (shown in FIGURE 6-4 and FIGURE 6-6) is used to adjust the
behavior or response of an alarm during an alarm condition.
The Alarm Responses tab is available at the ViewStation (shown in FIGURE 6-7) but is for
viewing purposes only. When a patient tile is assigned to the ViewStation, it will always
display the alarm response settings of the associated host central station patient tile.
The patient Alarm Responses tab is available at the WorkStation and functions in the
same manner as it does at the host central station but contains fewer sidebar buttons. Similar
to the central station, alarm response changes made at the WorkStation, with the exception
of the Print on Alarm settings, will be sent to the central station, View Only Workstation, and
bedside monitor (if applicable). The Print on Alarm setting is independent of the central
station settings or updates.
Automatic updating of the alarm response settings at the remote workstation will also occur
when:
• The monitoring device is placed in the Standby mode at the central station
• The monitoring device is not communicating with its host central station (Communications
Lost)
• Communication between the host central station and the ViewStation and/or the
WorkStation is lost (Central Communications Lost)
NOTE: The host central station(s) C-LAN configuration settings and
the software installed at the remote location dictates the
functionality available for each patient tile. For additional
information, refer to ‘‘The ViewStation and the
WorkStation’’ on page 2-4.
6.3.1 Accessing the Alarm Responses Tab
1. From the menu bar, select the Patient Alarms menu button. If the Patient Alarm
Setup tab displays, enter the password in the Password text box. The Alarm Limits
and Alarm Responses tabs are displayed.
2. Select the Alarm Responses tab. The Alarm Responses tab is displayed.