User Manual

Print Setup Tab (Patient) Patient Setup Functions
5 - 56 0070-10-0690-01 Panorama™ Operating Instructions
FIGURE 5-36 Patient Print Setup Tab (ViewStation)
FIGURE 5-37 Patient Print Setup Tab (WorkStation)
5.7.2 Changing a Patient’s Print Setup
This section outlines entering and modifying a patient’s print setup via the Print Setup tab.
Customizing a Patient’s Print Setup
1. Choose a patient tile by selecting its digital data or waveform area.
2. In the Print Setup tab, select a check box button to enable/disable the printing of a
parameter. The patient’s print setup settings are instantly changed.
The Parameters available in the Print Setup tab are dependent on the lead set and/or
monitoring device connected to the patient.
• A check mark in a parameter check box indicates that the parameter is selected and
will print the patient’s All Strip Report, Event Zoom-In, and Full Disclosure Zoom-In
Reports.
• An empty parameter check box indicates that the parameter is not selected and will
not print the patient’s All Strip Report, Event Zoom-In, and Full Disclosure Zoom-In
Reports.
5.7.3 Sidebar Buttons
The following sidebar buttons are used to expand the functionality of this tab.
Restore Previous Settings
Select the Restore Previous Settings sidebar button to return patient display settings to
those in use when the tab was opened.