User Manual

Discharge Tab Patient Setup Functions
5 - 38 0070-10-0690-01 Panorama™ Operating Instructions
5.3.4 Discharging a Patient from a Telepack Device
The same messages described in “Discharging a Patient from the Central Station and the
Bedside Monitor” on page 5-36 will be displayed, with one exception. If the Yes button is
selected after the message Are you sure you want to discharge this patient?
Selecting Yes will move the patient to the discharge list is displayed, the Telepack
will be discharged from the central station. Discharging a Telepack device can only be done
from the central station. Once discharged, all the patient information will be cleared.
5.3.5 Sidebar Button - Normal Screen
Select the Normal Screen sidebar button to return the display to the full screen mode, and
close all tabs, message boxes, and dialog boxes.
5.3.6 Troubleshooting
This section lists some of the potential messages and issues that may occur while using the
Discharge tab.
MESSAGE/ISSUE * REASON SOLUTION
No patient Selected! This message appears in the
demographic field when either
a patient tile has not been
selected or an empty tile was
selected.
Select an active patient tile.
The patient’s data and
submitted print jobs will
be deleted because at
least two of the following
fields: First Name, Last
Name or ID has not been
filled in. Do you still want
to proceed with the
discharge?
The selected patient does not
have at least two of the three
demographic fields completed.
The demographic fields include
First Name, Last Name, and
ID.
Select the No button to close
the dialog, then enter the
required demographic
information.
The patient’s data and
submitted print jobs will
be deleted because at
least two of the following
fields: First Name, Last
Name or ID has not been
filled in. Do you still want
to proceed with the
discharge? dialog box is
open and was automatically
closed without any user
interaction.
The bedside monitor has gone
into a Communications Lost
state.
Restore the connection
between the Panorama Central
Station and the monitoring
device. If unable to restore the
connection, select the
Discharge Patient button to
discharge the equipment from
the patient tile.
Unable to perform
operation on tile: Central
to Central Transfer Out in
progress.
A Central to Central transfer
Out has been initiated at the
source central station but not
accepted or rejected at the
destination central station for
the selected tile, and the
Discharge Patient button is
pressed in the Discharge tab
at the source central station.
Wait until the Central to
Central transfer is complete,
then discharge the patient.
* Messages are shown in all bold text.