User Manual

Transfer Tab Patient Setup Functions
5 - 22 0070-10-0690-01 Panorama™ Operating Instructions
5.2 Transfer Tab
The Transfer tab (shown in FIGURE 5-14) enables the transfer of a patient’s data from one
device to another. Two types of transfers can be performed through the Transfer tab:
• Room To Room Transfer Without Device
• Central To Central Transfer Without Device
The Transfer tab is not available at the ViewStation or the WorkStation. Patient transfers can
only be performed at a host central station.
5.2.1 Accessing the Transfer Tab
1. From the menu bar, select the Patient Setup menu button. The tabs associated with
patient setup are displayed.
2. Choose a patient tile by selecting its digital tile or waveform area.
3. Select the Transfer tab. The Transfer tab is enabled.
.
FIGURE 5-14 Transfer Tab
5.2.2 Room To Room Transfer Without Device
A Room To Room Transfer Without Device is used to transfer patient data stored at
the Panorama Central Station from one patient tile (the source) to another (the destination).
Historical patient data is preserved upon successful completion of the transfer, with the
exception of historical paging data. If Paging is enabled at the central station, a successful
Room to Room Transfer Without Device shall delete any rows in the Failed Pages tab for the
transferred patient.
For information regarding changes that occur at the destination tile when the transfer is
complete, refer to ‘‘Effects of the Transfer’’ on page 5-23.
The Room To Room Without Device button is enabled under the following conditions:
• When a patient tile actively monitoring a patient is selected as the source
• When a patient tile actively monitoring a patient, but placed in Standby mode, is
selected as the source