Installation Guide

Panorama WMTS Installation Guide 0070-00-0571 1 - 5
Introduction Site Survey, Planning and Design
3. Observe each frequency range for approximately 5 minutes in multiple locations within
the coverage area. If present, note these frequencies on the survey form.
4. Determine the available quadrants. Enter the available quadrants on the survey form.
5. Program the test transceiver to a frequency in a quadrant that is not in use by other
telemetry systems in the facility.
6. Connect a test antenna and antenna power adapter to the Spectrum analyzer.
7. Apply 9V DC power to the antenna adapter. Obtain a reference RF level on the
Spectrum analyzer by holding the test transceiver 1 meter from the antenna (shown in
FIGURE 1-1).
8. Using that reference measurement as a base line, move to the edges of the antennas
coverage area. Verify that the RF loss does not exceed 35 dbm from the reference
measurement level in any portion of the antenna's coverage area.
FIGURE 1-1
9. Repeat steps 6-8 for each antenna location.
NOTE: If the RF signal loss is greater than 35 dbm, the antenna
network must be redesigned in order to meet the product
specification.
1 meter
(3 ft 3 in.)
45 degree
angle
Ceiling
Transmitter