Installation Guide

Panorama WMTS Installation Guide 0070-00-0571 5 - 7
Programming and Configuring Telemetry Devices Communication verification
5.6 Communication verification
Bedside monitor to Wireless server
1. Turn on the bedside monitor. If the radio card is communicating with the Wireless
Server, the Server will display "WMTS Translator still communicating" (shown in
FIGURE 5-2).
FIGURE 5-2
2. Repeat for each bedside monitor being assigned to the system.
Telepack to Wireless Server
1. Install new batteries into a Telepack. If the Telepack is communicating with the Wireless
Server, the Server will display "WMTS Translator still communicating" (shown in
FIGURE 5-2).
2. Repeat for each Telepack assigned to the system.
Waiting for green signal from OSC
CB Server Created
WMTS Translator still communicating
WMTS Translator still communicating
WMTS Translator still communicating