Installation Guide

Assigning Equipment to the Central Station Programming and Configuring Telemetry Devices
5 - 6 0070-00-0571 Panorama WMTS Installation Guide
5.5 Assigning Equipment to the Central Station
After being programmed, the Telemetry Devices must be assigned to the central station
equipment list. Also, all wireless Servers must also be assigned to the equipment list.
NOTE: Prior to assigning telemetry devices to the system, they
must be programmed.
5.5.1 Telemetry Devices
Remain in the System Setup / Installation Setup tab and assign the Telemetry Devices.
1. Press the New button.
2. Press Tile and select the tile to be assigned: 0 being the first tile, 1 the second tile, etc.
Press Select.
3. Press Type and select the device type to be entered: i.e. Telepack WMTS
4. Press Select.
5. Press Label and use the onscreen keyboard to type a label for that tile. Press the Enter
key on the keyboard when the label is completed.
6. Press Device ID and enter the Device ID of the transceiver being assigned to that tile.
7. Press Done to complete the assignment for that device.
8. Repeat this procedure for all equipment to be assigned to the system.
9. After the equipment is assigned, press the Close Menu button.
Installing the Radio Card Into a Bedside Monitor
1. Remove the blank panel from the upper rear case of the bedside monitor.
2. Follow the instructions (P/N 0065-00-0311) included with the radio card kit to install
the radio card.