Installation Guide

Panorama WMTS Installation Guide 0070-00-0571 5 - 3
Programming and Configuring Telemetry Devices Programming Telepacks
5.3 Programming Telepacks
Each Telemetry device being connected to the system must be programmed prior to
assignment to the system. Programming is of Telepacks is done via the programming cable
(P/N 0012-00-1521-01).
NOTE: In order to put the Telepack into the programming mode,
the programming cable must be connected to the serial port
on the Telepack prior to applying power to the Telepack. If
the connection is broken while applying power to the
Telepack, the sequence must be re-done.
1. Remove the serial port cover from the bottom of the Telepack.
2. Connect the programming cable (P/N 0012-00-1521-01) to the Serial Port on the
bottom of the Telepack.
3. Connect the other end of the cable to Serial Port 1 on the Viewpoint (the one farther
from the edge, just below the mouse connector)
4. Install two (2) fresh 1.5 V "AA" batteries in the Telepack. Screw on the battery cap.
5. Verify the LA LED illuminates briefly, followed by the RA LED illuminated for
approximately 5 seconds.
6. Press the More tab.
7. Press the Wireless tab. The Programming Menu will be displayed (shown in
FIGURE 5-1).
FIGURE 5-1
8. Press the Read button. The Device ID, software and hardware versions, and connection
status will be displayed in their respective windows. Verify the Device ID matches the ID
on the serial number label of the Telepack.
If there is an error message in the Connect Window in the programming menu, check the
cabling between the Serial Port 1 on the central station to the programming cable, re-power
the Telepack and try again.