Installation Guide

Panorama WMTS Installation Guide 0070-00-0571 3 - 3
System Configuration Configuring the Wireless Server
WELAN IP Address
Assign the Server an appropriate WELAN IP Address (7.8.8.XXX). Verify that no other device
(Telemetry Server, ISM Access Point or ISM Telemetry Radio) being assigned to the network
has the same WELAN IP Address. (Default -7.8.8.1)
Device ID
Note the Device ID number. This will be assigned to the equipment list of the central station
Tower.
608 MHz WMTS Enable
Enable the WMTS devices by clicking on the check box. Failure to check this box will disable
the WMTS configuration.
608 MHz WMTS Configuration
Leave these settings at their default configurations. Changes will be made later in the
installation process.
Select the 608 MHz operating band for each Server on the system.
NOTE: Repeat the process for each Server. In order to avoid IP
conflicts complete the power up and configuration of one
server at a time.
NOTE: The TIM Transceiver ID is always zero with a one TIM
configuration regardless of the number of Servers on the
system.
Saving the Configuration
After setting these parameters, press the Save and Exit button. After a few seconds, a
confirmation window will appear. Press the YES button to save the settings.