Installation Guide

Installing the Antenna Network Components System Installation
2 - 6 0070-00-0571 Panorama WMTS Installation Guide
2.3 Installing the Antenna Network Components
2.3.1 Panorama Active Antenna
1. Remove the locking ring from the antenna.
2. Set all the DIP switches to the minimum gain (maximum attenuation) position (OFF)
(shown in FIGURE 2-3).
FIGURE 2-3
Installing Above the Ceiling
• Drill a 1¾-inch hole in the center of the ceiling tile where the antenna will be located. Do
not secure the antenna to the ceiling at this time.
Installing Below the Ceiling
Depending on the ceiling type and construction, special considerations will need to be
made.The antenna module is designed for flush mounting to hard ceilings.
All antenna modules MUST be installed such that the flexible antenna extends below the
ceiling grid.
Connect the coax cable to the antenna RF connector. Do not attach the flexible antenna to the
antenna module at this time.
2.3.2 RF Splitters
Connect each coax cable to the appropriate port on each splitter.
2.3.3 Connecting the Antenna System to the Wireless Transceiver
Connect the coaxial cable from antenna Main branch (A) to the "A" input on the front of the
TIM Transceiver (shown in FIGURE 2-4).
Connect the coaxial cable from antenna Diversity branch (B) to the "B" input on the front of
the TIM Transceiver (shown in FIGURE 2-4).