Installation Guide

Panorama WMTS Installation Guide 0070-00-0571 2 - 5
System Installation Setting Up the TIM Transceiver
2.2 Setting Up the TIM Transceiver
1. Mount the TIM Transceiver to the equipment rack with four screws.
2. Connect the AC line cord to the rear of the transceiver.
3. Plug the line cord into an outlet on the UPS.
4. Connect the LVDS cable coming from the Wireless Server(s) to appropriate LVDS
connectors (marked DS1 through DS4) on the rear of the TIM Transceiver (shown in
FIGURE 2-2).
NOTE: The "Master Server" must be connected to the port marked
DS 1 on the rear of the TIM Transceiver.
NOTE: The interface cable between the Panorama Telemetry Server
and the TIM Transceiver is P/N 0012-00-1522-XX (0.5
meter, 1 meter and 1.5 meter in length). Insure the TIM
Transceiver is located close enough to the Panorama
Telemetry Server to make this connection.
FIGURE 2-2
DS 1 DS 4DS 2 DS 3
AC Power
O
I
On/Off
Switch