User's Manual

Quick Reference Guide Getting Started
2 - 16 0070-00-0575-50 Panorama™ Operating Instructions
4. Select a patient’s Standby location.
a. Select a location from the patient location list
b. Choose the Select button
To activate Standby mode at the bedside monitor:
• Select the STANDBY button on the front of the bedside monitor. This method places both
the bedside monitor and the Panorama Central Station in Standby mode.
To remove patient from Standby mode at the Panorama Central Station:
1. Select the Patient Setup menu button.
2. Choose a patient tile by selecting its digital data or waveform area.
3. Select the Standby tab.
4. Select the Resume Monitoring button. Monitoring is resumed at the Panorama
Central Station.
To remove patient from Standby mode at the Panorama Central Station and the bedside
monitor:
• Select the STANDBY button on the front panel of the bedside monitor. Monitoring
resumes at the Panorama Central Station and the bedside monitor.
For additional information on Standby, refer to "Standby Tab’’ on page 5-34.
2.4.3 Discharge
The discharge function discharges a patient from a patient tile and resets the Panorama
Central Station for the next patient.
NOTE: Discharging a patient from the Panorama does not effect the
information that is stored at the bedside monitor.
To discharge a patient from the Panorama Central Station:
1. Select the Patient Setup menu button.
2. Choose a patient tile by selecting its digital data or waveform area.
3. Select the Discharge tab.
4. Select the Discharge Patient button.