User's Manual
The Main Screen Getting Started
2 - 6 0070-00-0575-50 Panorama™ Operating Instructions
• Alarms on/Alarms off icon
• ST analysis icon
• Arrhythmia analysis icon
• Heart Rate parameter lead
For information regarding supported devices and the parameters measured by each, refer to
‘‘Supported Devices’’ on page 1- 4. For information regarding the parameters displayed in
the digital data tile, refer to ‘‘Parameter Specifications’’ on page 13- 2.
The following table lists icons that may be shown in a digital data tile.
During an alarm condition, the parameter’s digital data tile flashes in the color that is
associated with its assigned alarm priority.
• The tile flashes red when a Priority 1 alarm occurs.
• The tile flashes yellow when a Priority 2 or a Priority 3 alarm occurs.
REC Button
The REC button (FIGURE 2-3) prints an All Strips Report for the selected patient tile. Selecting
the REC button sends a print request to the Print Status tab and prints an All Strips Report.
The All Strips Report provides real-time monitoring data for the selected patient. For
additional information, refer to the ‘‘All Strips Report’’ on page 8- 2.
Patient Status Line
The Patient Status line (FIGURE 2-3) displays patient demographic information, physiological
event messages and technical event messages. Demographic information (Last Name, First
Name, Bed, ID) is only shown if it was entered in the Demographics tab. Demographic
information is displayed as selected in the Unit Choices tab.
Digital Data Icons
ICON MEANING
All of the alarms for the selected patient are enabled.
At least one alarm for the selected patient is disabled.
Arrhythmia Analysis is active for the selected patient. This icon is only
applicable to the Heart Rate tile.
ST Analysis is active for the selected patient. This icon is only applicable to
the Heart Rate tile.
Lead labels for the Heart Rate parameter include I, II, III, aVR, aVL, aVF, V,
V1, V2, V3, V4, V5 and are dependent on the lead set used. This icon is
only applicable to the Heart Rate tile. For additional information, refer to
‘‘Parameter Specifications’’ on page 13- 1.
Lead labels are always shown in the Heart Rate tile when an ECG lead is
used.
a
VR