User's Manual

Operating Instructions Telepack (Optional)
10 - 10 0070-00-0575-50 Panorama™ Operating Instructions
CAUTION: Visually inspect the battery compartment for any foreign
object prior to use.
CAUTION: The Telepack may not function if the batteries installed in the
device are corroded.
The Telepack will not transmit data to the Panorama Central Station once the batteries have
become depleted. To test the batteries, press the Lead/Link/Battery Test/CHECK button and
confirm that both the Link LED and the Battery LED is lit.
When not in use, the Telepack device should be stored without batteries.
10.4.1.2 Programming the Telepack
This section describes how to program the Telepack. For additional information, refer to the
“Wireless Tab” on page 9-46.
NOTE: Programming and assigning of the Telepack must be
performed by authorized service personnel only.
CAUTION: The Telepack should not be attached to the patient when the
device is being programmed into the system.
To program the Telepack, follow these steps:
1. Connect the Telepack service mode cable from the Panorama Central Station (COMM
port 1 in the right rear of the Panorama Central Station) to the serial port provided on
the base of the Telepack device.
2. Insert the batteries into the device. For additional information, refer to “Inserting
batteries” on page 10-9.
3. From the Panorama Central Station main screen, select the System Setup menu
button.
4. Select the Installation Setup tab, and enter the System password. For additional
information, refer to “Entering a Password” on page 6-2.
5. Select the More tab, then select the Wireless tab.
6. Select the Read sidebar button. The information from the Telepack device is displayed
in the appropriate fields.
7. For a Telepack-2.4, if necessary, modify the information in the following fields: Telepack
IP, Subnet Mask and Network Name.
8. Select the Program sidebar button. A dialog box appears.
9. Select the Yes button to confirm. The message “Wireless device programmed
successfully” appears confirming that the Telepack was programmed correctly.
NOTE: If the Telepack device is not connected properly or if the
Panorama Central Station is unable to detect the device, the
error message, “Error: Could not receive data” appears at
the Panorama Central Station.
10.4.1.3 Entering the Telepack to the Equipment List
The Telepack device should be entered to the Panorama Central Station Equipment List using
the Equipment Setup tab. For additional information about entering a Telepack device to
the Panorama Central Station, refer to “Entering New Equipment” on page 9-22.