User's Manual

Panorama™ Operating Instructions 0070-00-0575-50 10 - 9

Telepack (Optional) Operating Instructions

10.4 Operating Instructions

This section of the manual provides instructions for programming the Telepack device for use

with the Panorama Central Station.

10.4.1 Initial Setup of Telepack

The Panorama Central Station should be installed and running before you begin to set up the

Telepack device. For additional information, refer to the Panorama Service Manual

(P/N 0070-00-0457).

The following items are required to initially install and program the Telepack:

• Telepack device

• 2 AA size alkaline or lithium (for Telepack-608 only) batteries

• Telepack Service Mode Cable

10.4.1.1 Inserting batteries

To activate the Telepack device, insert the 2 AA size alkaline or lithium (for Telepack-608

only) batteries in the Telepack battery compartment. For the Telepack-2.4, the positive (+) end

of each battery should be facing downward. For the Telepack-608, the positive (+) end of

each battery should be facing upward. (Use the label on the back of the Telepack as a

guide.) Secure the end cap of the battery compartment by twisting firmly in the clockwise

direction.

The Telepack automatically performs an initial system check if the batteries are installed

properly.

FIGURE 10-5 Rear panel

Telepack-2.4

FIGURE 10-6 Rear panel

Telepack-608

Datascope Corp., Mahwah, NJ 07430

HIS DEVICE COMPLIES WITH PART 15 OF THE

FCC RULES. SEE INSTRUCTION MANUAL.

FCC ID: DXXWT0191-00000

P/N

S/N

IPX 7