User's Manual

Panorama™ Operating Instructions 0070-00-0575-50 10 - 7
Telepack (Optional) Indicator Lights
This test determines if the patches are connected based on thoracic impedance. If a patch
adhesive is not sticking, a patch is dry, or the skin gel is dry, the test fails.
The Telepack’s ECG Lead LED indicator lights remains on for approximately 10 seconds
during the test sequence, indicating that the Telepack has good lead connectivity. An unlit
ECG Lead LED light indicates that the Telepack has no lead connectivity.
NOTE: If a 3-wire Lead set is used (for Telepack-608 only), three
lights will illuminate. If a 5-wire Lead set is used, all five
indicator lights are illuminated.
10.3.2 Link Status LED Indicator Light
The Telepack Link Status LED indicator light verifies the Telepack’s connection to the
Panorama Monitoring Network.
The Link Status LED indicator light remains on for approximately 10 seconds during the initial
power up and during the test sequence.
Press the Test/CHECK button to verify the Telepack’s link status with the wireless network.
The Telepack’s Link Status LED indicator light shows the results of the link status test.
NOTE: When the Test/CHECK button is pressed, all of the device LED
indicator lights are tested simultaneously.
For the Telepack-2.4, the results can be interpreted as follows:
A steadily lit Link Status LED indicates that the Telepack is successfully communicating with a
Panorama Central Station. A flashing Link Status LED indicates that the Telepack’s radio
signal is in range of the wireless network, but is not communicating with the Panorama
Central Station. An unlit Link Status LED light indicates that the Telepack’s radio signal is out
of range of the wireless network, or the battery needs to be replaced.
For the Telepack-608, the results can be interpreted as follows:
A steadily lit Link Status LED indicates the Panorama Instrument Radio is working. An unlit
Link Status LED light indicates that the Telepack’s radio signal is out of range of the wireless
network, or the battery needs to be replaced.
10.3.3 Battery Status LED Indicator Light
The Telepack Battery Status LED indicator light verifies the status of the Telepack’s batteries.
Press the Test/CHECK button to verify the Telepack’s battery status.
NOTE: When the Test/CHECK button is pressed, all of the device LED
indicator lights are tested simultaneously.
During this test sequence, the Battery Status LED indicator light will remain on for
approximately 10 seconds if the Telepack batteries have more than 2 hours of battery life
remaining. A flashing Battery Status LED light indicates the Telepack batteries have less than
2 hours of battery life remaining. An unlit Battery Status LED light indicates the Telepack
batteries should be replaced immediately, or that they have been incorrectly inserted.