User's Manual

Wireless Tab System Setup Functions
9 - 50 0070-00-0575-50 Panorama™ Operating Instructions
Selecting the Program sidebar button will display the Are you sure you want to
program the wireless device? message.
• Select the Yes button to program the wireless device. The Wireless device
programmed successfully. message displays.
• Select the No button to cancel the programming of the connected device.
NOTE: The Program sidebar button will be disabled until a valid
device has been detected by the Panorama Central Station.
9.16.4 Error Log Sidebar Button
Select the Error Log sidebar button to display the log of error messages for the connected
wireless device. Selecting the Error Log sidebar button will bring up the Error log for the
connected wireless device. When the Error Log sidebar button is selected the button is
changed to the Telepack sidebar button. FIGURE 9-21 shows the Error Log for the
Wireless tab.
FIGURE 9-21 Error Log for the Wireless tab
NOTE: The Error Log sidebar button will be disabled until a valid
device has been detected by the Panorama Central Station.
9.16.5 Device ID
The Device ID field displays the identification number that was assigned to the connected
wireless device. A Device ID has a maximum of 8 alphanumeric characters. Data is shown in
the Device ID field when the Wireless tab’s Read sidebar button is selected. If the read was
not successful the Device ID field will remain blank. To view the connection status of the
wireless device check the message in the Connect field. The Device ID field cannot be edited
and has a factory default setting of blank.
Device ID is set up in the Equipment List tab. For additional information on setting up a
Device ID and the requirements of a Device ID, refer to the ‘‘Equipment Setup Tab’’ on page
9-21.