User's Manual

Panorama™ Operating Instructions 0070-00-0575-50 9 - 49
System Setup Functions Wireless Tab
Protocol Selection
The Protocol Selection button displays the protocol selection for the assigned device. It
sets the protocol of the attached device. Protocol selection options include Visa™ and
OpenNet.
• Data is shown in the Protocol Selection field when the Wireless tab’s Read sidebar
button is pressed and has a factory default setting of blank. If the read was not
successful the Protocol Selection field will remain blank. To view the connection status
check the message in the Connect field.
• A Protocol Selection data can be programmed in a connected device by selecting the
Program sidebar button.
NOTE: The Protocol Selection button will not be shown when the
device cannot be recognized or there is a Read error.
Channel Type
The Channel Type button displays the selected channel for the assigned device. It selects
the channel type of the attached device. Channel type options include Medium and High.
• Data is shown in the Channel Type field when the Wireless tab’s Read sidebar button
is pressed and has a factory default setting of blank. If the read was not successful the
Channel Type field will remain blank. To view the connection status check the message
in the Connect field.
• A Channel type can be programmed in a connected device by selecting the
Program sidebar button.
NOTE: The Channel Type button will not be shown when the device
cannot be recognized or there is a Read error.
9.16.3 Sidebar Buttons
The following sidebar buttons are used to expand the functionality of this tab.
9.16.3.1 Read
Select the Read sidebar button to retrieve status parameters from the connected wireless
device when it is connected to the Panorama Central Station in Service mode. A device is in
Service mode when it is connected to the Panorama Central Station serial port 2 via the
device’s programming cable.
Selecting the Read button will attempt to read from the connected wireless device.
• A successful read from a known device will display the fields and sidebar buttons
appropriate to the attached device.
• An unsuccessful read will only display a connect status in the Connect field. The Device
ID, Software Version and Hardware Version fields will be blank.
9.16.3.2 Program
Select the Program sidebar button to program information in a wireless device when it is
connected to the Panorama Central Station in Service mode. A device is in Service mode
when it is connected to the Panorama Central Station serial port 2 via the device’s
programming cable.