User's Manual

System Reports Tab Report Functions
8 - 30 0070-00-0575-50 Panorama™ Operating Instructions
• An ECG lead label
• A wave gain scale bar and a calibration pulse for wave gains less than 30 mm/mV
• A calibrated grid
• Current ECG monitoring label
• A continuous straight line for active ECG leads that are not connected
Non-ECG Waveforms
The non-ECG waveforms shown in the All Strips (All Patients) Report are based on the non-
ECG waveforms that are in use and the non-ECG waveforms that are selected to be printed.
The report only includes non-ECG parameters if they are in use at the time of the print
request.
All non-ECG waveforms in the report contain a parameter label and a unit of measure label.
Non-ECG waveforms in the report may contain a wave gain scale bar. If a non-ECG
waveform is unavailable at the time of the print request, the report prints blank data for the
specified time period.
• If the IBP waveform was labeled at the bedside monitor, the report contains that IBP label.
• If the Anesthetic Agent was identified at the bedside monitor, the report contains that
Agent label.
8.2.1.4 Footer
The report contains a footer at the bottom of every page. The footer includes the following:
• The date and time of the print request. The format displayed is taken from the System
Date/Time tab.
• A centered page number.
• The name of the Panorama Central Station where the report was generated.
8.2.1.5 Printing an All Strips (All Patients) Report
The All Strips (All Patients) Report prints in portrait orientation, using the following method:
• Select the Print All Strips/All Patients button in the System Reports tab. Selecting
this button sends a print request, for each patient, to the printer.
NOTE: Requesting this report posts a print job in the system Print
Status tab.