User's Manual

Panorama™ Operating Instructions 0070-00-0575-50 8 - 25
Report Functions Patient Reports Tab
• The third column of this report displays the High alarm limit for the parameter specified.
• The fourth column of this report displays the Low alarm limit for the parameter specified.
• The fifth column of this report displays the alarm priority assigned to the parameter
specified.
• The sixth column of this report displays the Print on Alarm response assigned to the
parameter specified.
• The seventh column of this report displays the Save to Event alarm response that has been
assigned to the parameter specified.
8.1.7.3 Footer
The Patient Alarm Report’s contains a footer at the bottom of the page. The footer includes the
following:
• The date and time of the print request. The format displayed is taken from the System
Date/Time tab.
• A centered page number.
• The name of the Panorama Central Station where the report was generated.
8.1.7.4 Printing a Patient Alarm Report
This Patient Alarm Report is printed in portrait orientation, using any of the following
methods:
• Select the Patient Alarm Report button in the Patient Reports tab.
• Select the Print sidebar button in the patient’s Alarm Limits tab.
NOTE: Requesting this report posts a print job in the system Print
Status tab.
8.1.8 Troubleshooting
This section lists some of the potential messages and issues that may occur while using the
Patient Reports tab.
MESSAGE/ISSUE * REASON SOLUTION
All report buttons are disabled. A patient is not currently
selected.
Select a patient before trying to
print a report.
The ST REPORT button is
disabled.
The selected patient does not
have ST enabled.
Enable ST for the selected
patient before trying to print an
ST report.
* Messages are shown in all bold text.