User's Manual

xiv 0070-00-0575-50 Panorama™ Operating Instructions
Warnings
WARNING: Loading any unauthorized software on the Panorama
Patient Monitoring Network render the application
unsuitable for medical patient monitoring.
WARNING: Do not attempt to load any devices or device drivers onto
the Panorama Central Station or Panorama Telemetry
Server. If the user connects or attempts to connect any
unauthorized equipment, the Panorama Patient Monitoring
Network may not operate as intended.
WARNING: Only qualified and trained personnel or Datascope Service
personnel should attempt to service Datascope equipment.
Service is defined as any activity requiring the cover to be
removed for internal adjustments, parts replacements,
repairs or software upgrades of any kind to insure
compatibility.
WARNING: To insure compatibility with the operating system and
applications software, use only Datascope Corp. supplied
and/or approved components to repair any part of the
Panorama Patient Monitoring Network.
WARNING: Incorrect setting or silencing of patient alarms can
jeopardize patient safety.
WARNING: Possible Explosion Hazard - Do not use in the presence of
flammable gases. This instrument is not explosion proof in
the presence of flammable anesthetics.
WARNING: Route cables neatly. Ensure cables are not in the way of
patient or hospital personnel.
WARNING: Do not incinerate batteries, possible explosion may occur.
WARNING: The Panorama Central Station and the Panorama Telemetry
Server must utilize the hospital emergency power system.
Failure to do so will result in loss of monitoring during
extended periods of power failure. The back-up power time
period, for the Panorama Patient Monitoring Network, is
limited.
WARNING: Cardiac arrhythmia and respiratory apnea conditions are
not detected by the Panorama Central Station. They are
alarm conditions that are detected by compatible
physiological monitor(s) connected to the Panorama Central
Station.
WARNING: The 18.1" flat panel may tip over, if the display head is
inclined to an angle greater than 45° backward tilt. If the
user elects to have the display head inclined to an angle
greater than 45° backward tilt, the flat panel must be
attached to a secure mounting surface via three screw
locations on the bottom of the base.